OPERATION
MUFFLER
GASOLINE
FILLER CAP
CHOKE
CON-
TROL
SAFETY
IGNITION
KEY
ON / OFF
SWITCH
PRIMER
FUEL
RECOIL (AUXILIARY) STARTER HANDLE
NOTE: ITEMS ABOVE
ARE SHOWN IN
THEIR TYPICAL
LOCATION ON THE
ENGINE. ACTUAL
LOCATION MAY VARY
WITH THE ENGINE
ON YOUR UNIT.
AUGERS
ELECTRIC | AUGER |
| DISCHARGE CHUTE CONTROL LEVER | ||
START | CONTROL |
|
|
| |
BUTTON | LEVER | DRIVE SPEED | DEFLECTOR | TRACTION | |
|
| REMOTE | DRIVE | ||
|
| CONTROL LEVER | |||
POWER |
| CONTROL | CONTROL | ||
|
|
| |||
CORD |
|
|
| LEVER | LEVER |
PLUG |
|
|
|
|
|
| CHUTE |
|
|
|
|
DEFLECTOR |
|
|
|
| |
LH TURN
TRIGGER
DISCHARGE
CHUTE
| LIGHT | |
HANDLE | ||
KNOB | ||
| ||
| MUFFLER | |
| TOOLBOX |
SKID PLATE
FIG. 10
MEETS A.N.S.I. SAFETY REQUIREMENTS
Our snow throwers conform to the standards of the American National Standards Institute.
Toolbox - used to store spare shear bolts, locknuts and wrench.
Safety ignition key - must be inserted for the engine to start and run. Remove when snow thrower is not in use.
Electric start button - used for starting the engine.
Recoil (auxiliary) starter handle - used for starting engine.
Primer - pumps additional fuel from the carburetor to the cylinder for use when starting a cold engine.
Choke Control - used for starting a cold engine. ON / OFF switch - used to STOP the engine.
LH and RH turn triggers - used to steer the snow thrower.
Drive speed control lever - used to select forward or reverse motion and speed of snow thrower.
Traction drive control lever - used to engage
Auger control lever - used to engage auger motion (throw snow).
Discharge chute control lever - used to change the di- rection the snow is thrown.
Deflector remote control lever - used to change the distance the snow is thrown.
Skid plate - used to adjust height of scraper bar from the ground.
9
