![](/images/new-backgrounds/1175889/17588919x1.webp)
STARTING THE UNIT
Gasoline is very dangerous.
Serious injury or death may result from fire caused by gasoline contacting hot surfaces.
1.Do not fill fuel tank with engine running.
2.Do not spill fuel while refilling tank.
3.Do not mix oil with gasoline.
4.Follow all instructions and warnings in the engine
manual.
PRE-START PREPARATION
Before starting the generator, check for loose or missing parts and for any damage which may have occurred during shipment.
This generator must not be operated without all factory installed heat shields in place. Failure to comply may cause the fuel tank to overheat and result in personal injury from fire.
STARTING THE ENGINE
1.Check oil level and fuel.
2.Disconnect all electrical loads from the unit.
3.Open fuel shut off valve.
4.Adjust choke as necessary.
5.Set the engine switch to the “ON" position.
6.Pull on the starter rope with fast steady pull. As the engine warms up, readjust the choke. On electric start models, push the start button. Release button after the engine starts.
Allow generator to run at no load for five minutes upon each initial
•Provide adequate ventilation for toxic exhaust gases and cooling air flow.
•Do not start or run the generator in an enclosed area, even if door or windows are open.
•Engines give off carbon monoxide, an odorless, colorless, poison gas.
•Breathing carbon monoxide can cause nausea, fainting or death.
APPLYING LOAD
This unit has been pretested and adjusted to handle its full capacity. When starting the generator, disconnect all load. Apply load only after generator is running. Voltage is regulated via the engine speed adjusted at the factory for correct output. Readjusting will void warranty.
When applying a load, do not exceed the maximum wattage rating of the generator when using one or more receptacles. Also, do not exceed the amperage rating of any one receptacle.
SHUTTING THE GENERATOR OFF
1.Remove entire electrical load.
2.Let the engine run for two minutes without load.
3.Move the engine switch to the “OFF” position.
4.Do not leave the generator until it has completely stopped.
5.Close the fuel shut off valve if the engine is to be put in storage or transported.
6.If a cover is used, do not install until unit has cooled.
BREAK-IN PROCEDURE
Controlled
Do not apply heavy electrical load during
www.powermate.com |
| 10 |
| Customer Hotline |
|
|
|
|
|