Powermatic 2000 operating instructions Introduction Specifications

Introduction

This manual is provided by WMH Tool Group covering the safe operation and maintenance procedures for a Powermatic Model 2000 Table Saw. This manual contains instructions on installation, safety precautions, general operating procedures, maintenance instructions and parts breakdown. This machine has been designed and constructed to provide years of trouble free operation if used in accordance with instructions set forth in this manual. If there are any questions or comments, please contact either your local supplier or WMH Tool Group. WMH Tool Group can also be reached at our web site: www.wmhtoolgroup.com.

Specifications
Model number		2000
Stock Number
3HP, 230V, 60Hz, 1 Phase, 3600 RPM, TEFC		1791999
5HP, 230V, 60Hz, 1 Phase, 3600 RPM, TEFC		1791998
5HP, Prewired 230V (for 460V see Note below), 60Hz, 3 Phase, 3600 RPM, TEFC		................. 1791997
Table size with standard extensions (L x W/in.)		42 x 30 1/2
Table size without extensions (L x W/in.)		22 x 30 1/2
Arbor diameter (in.)		5/8
Saw blade diameter (in.)		10
Arbor speed (RPM)		4300
Left tilt range		0–45
Maximum depth of cut (in.)	3-1/8 at 90-degrees; 2-1/8 at 45-degrees
Maximum diameter of dado (in.)		8
Maximum width of dado cut (in.)		13/16
Drive system		Poly-V Belt
Table height to floor (in.)		34-1/2
Dust port diameter (in.)		4
Shipping weight (saw only)	All Models: Net: 540 lbs, Gross: 604 lbs

Note: For 460V operation, magnetic switch (Part No. PM2000-293C) must be purchased separately and installed. A qualified electrician is recommended.

The above specifications were current at the time this manual was published, but because of our policy of continuous improvement, WMH Tool Group reserves the right to change specifications at any time and without prior notice, without incurring obligations.

Read and understand the entire contents of this manual before attempting assembly or operation! Failure to comply may cause serious injury

6