Brake Pedal
An alternate method of stopping the machine is to press the brake pedal, shown in Figure 29. The band saw will shut off when the brake pedal is pressed.
The brake pedal is also useful for stopping the blade quickly, instead of waiting for the blade to coast slowly to a stop after the machine has been shut off.
Operation
General Procedure
1.Make sure the blade is adjusted correctly for tension and tracking.
2.Adjust blade guide assembly so that the guide bearings are just above the workpiece (about 3/16”) allowing minimum exposure to the blade. See Figure 30.
3.If using the fence, move it into position and lock it to the guide rail. If you are using the miter gauge for a crosscut, the fence should be moved safely out of the way.
4.Turn on the band saw and allow a few seconds for the machine to reach full speed.
Whenever possible, use a push stick,
5.Place the straightest edge of the workpiece against the fence, and push the workpiece slowly into the blade. Do not force the workpiece into the blade.
When cutting, do not overfeed the blade; overfeeding will reduce blade life, and may cause the blade to break.
6.When cutting long stock, the operator should use roller stands, support tables, or an assistant to help stabilize the workpiece.
Figure 29
Figure 30
22
