Powermatic PM3000, PM2000, 55, 72A Unpacking, Rail Installation on a Powermatic Table Saw

Unpacking

Open shipping cartons and check that all parts are intact. Report any damage immediately to your distributor. Read the instruction manual thoroughly for assembly, alignment, and maintenance instructions.

Box contents

Box One

1 Accu-Fence (A)

1Lock Lever Knob (B)

2Plastic Shims (not shown)

1 Owner’s Manual (not shown)

Box Two

1Front Rail (C)

1Back Rail (D)

1Guide Tube (E)

2End Caps (not shown)

1 Hardware Bag (see contents below)

Contents of Hardware Bag (shown at right)*

25/16-18 x 7/8" Hex Cap Screw

65/16-18 x 1-1/2" Hex Cap Screw

145/16" Flat Washer

85/16" Lock Washer

65/16" Hex Nut

101/4-20 x 1-1/2" Flat Head Screw

81/4-20 x 3/4" Hex Cap Screw

101/4" Flat Washer

181/4" Lock Washer

101/4" Hex Nut

*NOTE: Hardware bag is shipped inside the guide tube.

Rail Installation on a

Powermatic Table Saw

Tools required

‰10mm and 12mm wrenches

‰Cross-Point (“Philips”) screwdriver

‰5mm hex wrench

‰Adjustable square

‰Rubber mallet (or hammer and wood block)

‰Straight edge

The following instructions are for installing the Accu-Fence and Rail System on a Powermatic Model 66, 72A, PM2000 or PM3000 table saw. The rails should bolt up to the Powermatic saw without any drilling.

4

Contents of Box 1

Contents of Box 2

Contents of Hardware Bag