Installation
3. Start the UPS by pressing the switch as shown in Figure 2 or Figure 4 on page 4. The µindicator illuminates indicating that power is available from the UPS output receptacles.
The unit beeps and the front panel LEDs illuminate several times. The µindicator remains on, indicating normal operation.
If the unit continues to beep, or if the µindicator is off even though input power is available from the wall outlet, see “Troubleshooting” on page 15.
NOTE Let the unit charge the battery for at least 3 hours. You may use the unit while the battery charges, but the battery backup runtime will be reduced until the battery is fully charged. This will take up to 8 hours after a full discharge while the UPS is fully loaded.
UPS Top and Side Panels
Figure 1 and Figure 2 identify features of the 120V (USA) models, with attached input line cord. Figure 3 and Figure 4 identify features of the 230V (European) models, which have a connector for the input line cord as well as IEC output receptacles.
Fault Indicator Power Indicator
Output Receptacles |
|
| Output Receptacles |
|
|
|
| ||||
(Battery and Surge Protection) | (Surge Protection Only) | ||||
Figure 1. 120V Model Top Panel
Powerware3110 User’s Guide S Rev B www.powerware.com | 3 |
® |
|