Powerware FCC 15 manual Installing the Modbus Card into an X-Slot, C A U T I O N

INSTALLING THE MODBUS CARD

Installing the Modbus Card into an X-Slot

C A U T I O N

To prevent electrostatic discharge (ESD), place one hand on an unpainted metal surface such as the UPS rear panel.

1.Remove the X-Slot cover (or existing X-Slot module) on the UPS rear panel. Retain the screws (see Figure 5).

NOTE Some UPSs may have another X-Slot module already installed (such as the Powerware 9125 UPS). If there is a communication cable attached to this module, disconnect the cable and then remove the X-Slot module.

Figure 5. Removing the Single-Port Module

2.Install the Modbus Card into the X-Slot on the UPS.

Align the Modbus Card with the slot guides and slide the card into the slot until it is firmly seated.

Secure the Modbus Card with the screws removed in Step 1.

6 EATON Powerware® Modbus® Card User’s Guide S 164201376 Rev C www.powerware.com