Installing the Data Analyzer
Installing the Analyzer Software
The “Install (analysis)” window allows you to track summary progress of the installation process. Use the “Logfile” feature to display a detailed status, which is logged to /var/adm/sw/swagent.log.
Verifying Installation
Check the end of the swinstall log file /var/adm/sw/swagent.log to ensure that there were no errors during the installation. If errors occurred, correct the problem and repeat the swremove and swinstall steps.
The Data Analyzer software contains a sample capture file. This file is installed into the directory /var/opt/acc/log and is called sample.eve. This file can be viewed using the pdisplay program. To try this, run pdisplay from the shell prompt.
If neither the ZCOM subsystem nor the pcapture program are currently up and running, the following message will be displayed:
$ pdisplay
Bad zinit call, error:ZCOM system is not started up Bad zopen call, error:Must call ZINIT first
Bad zopen call, error:Must call ZINIT first Bad zname call, error:Must call ZINIT first
***** Warning *****
Cannot find primary ZLU of pcapture - pcapture probably not running Some functions of this program will not be available
***** Warning *****
Cannot get storage offset for label ANLYZR,Error:Must call ZINIT first Display>
If the ZCOM subsystem is up and running but the pcapture daemon is not running, the following message will be displayed:
$ pdisplay
***** Warning *****
Cannot find primary ZLU of pcapture - pcapture probably not running Some functions of this program will not be available
***** Warning *****
Display>
20 | Chapter 2 |