HP UX 11i v2 I/O Cards manual Introduction, General Procedures

Typical X.25 and Data Analyzer Sessions

Introduction

Introduction

This section provides the results of actual Data Analyzer sessions that were run using this software. The sessions were run on an 8-Channel multiplexer.

Because the 8-Channel multiplexer was not designed to provide ISDN service, only an X.25 session is described for this product.

General Procedures

The process involved with all sessions described in this appendix is generally as follows:

•Ensure that the ACC multiplexer hardware and its base system and X.25 software are properly installed (per supplied manuals );

•Ensure that the X.25/ACC configuration has been properly set up: refer to the X.25/ACC Installation and Configuration Guide as needed;

•Start up the ZCOM muliplexer subsystem (described below);

•Establish an X.25 connection via the ACC Multiplexer (described below);

•Send packets over the connection using the X25Check utility (described below);

•Run Data Analyzer’s pdisplay program to observe trace of the captured file.

These sessions were run with the HP-UX utility Script executing in the background, to preserve a trace of all terminal activity involved with the procedures.

54 Appendix B