Cut any wire ties that secure the cable to the stabilizer. Unwrap the cable and remove any kinks. Feed the cable through the console bracket as shown in the illustration.
Slide the console bracket into the right stabilizer and align the three mounting holes. Insert the top two buttonhead screws (C) with lock washers (D). Partially tighten.
CAUTION: Make sure you do not pinch the cables while attaching the console bracket. Any damage caused during installation is not covered by the Precor Limited Warranty.
Insert the bottom buttonhead screw (C) with lock washer (D). Partially tighten.
Slide the left stabilizer onto the console bracket and secure its base using four hex head screws (A) and four washers (B). Partially tighten.
Note: You may need to pivot the stabilizer back and forth to fit it snugly onto the console bracket.
Return to the console bracket and insert the three remaining fasteners. Fully tighten all six console bracket fasteners.
|
|
|
|
EFX5.25 Elliptical Fitness CrossTrainer Assembly Guide | 4 | ||
