Diagram 4 | Secure the |
| upright |
| column |
| support. |
Upright column |
|
|
Front plate
Hex key (F)
Motor
6.Secure the upright column support to the base by lifting it into position onto the base mounting plate. See Diagram 4. Align the bolt holes and hold onto the upright column support as you insert the
7.With the upright column support secure, replace the hood by aligning the screw holes on the hood with the holes in the base frame. Tighten the screws securely using a phillips head screwdriver.
8.Loosen the bolts in the upper handrail clamp using the 3/16" hex key (H). You do not need to remove the bolts.
Diagram 5 | Secure the |
| handrails |
| into upper |
| handrail |
| clamp. |
Electronic console |
|
Handrail clamp |
|
Handrail clamp bolt |
|
Upper handrail |
|
9.Insert the upper end of a handrail into the upper handrail clamp. Using one hand, apply pressure on the portion of the handrail going into the clamp while, with the other hand, lift and lower the base of the handrail. This rotating motion helps move the handrail into place. The handrail is properly positioned when the black foam wrap touches the clamp as shown in Diagram 5. Repeat this step for the other handrail.
Important: Do not fully tighten the upper handrail clamp bolts until you have installed the lower handrail clamps. The instructions are on the next page.
page 11
