Precor 9.21i owner manual Hood, Lower board

Diagram 2	Remove the
	hood.
Hood
Screw
Base
Wheel

2.Remove the treadmill’s hood using a phillips head screwdriver. Unscrew all six screws

and set them aside. See Diagram 2. Grasp both sides of the hood with your hands and pull up to remove the hood from the base.

Diagram 3	Plug
	connector
	into lower
	board.
Lower board	PRECOR	PRECOR
Proper tab alignment on receptacle
Lower board’s cables
Front plate
Ribbon cable connector
Upright column support

3.Set the upright column support assembly on the front plate. Route the ribbon cable under the lower board’s cables. See inset in Diagram 3.

4.Align the tab on the ribbon cable connector with its counterpart located on the receptacle on the lower board. Plug the connector into the receptacle. See Diagram 3. The plastic flanges on the receptacle should clip onto the connector when you plug it in. Since the connector is designed to engage in one direction only, do not force the connector into the receptacle.

5.Place a lock washer (D) onto each frame-to-base bolt (A). (The bolts and washers are found in the hardware kit.) Set the bolts and washers within easy reach of the upright column support.

page 10