EFX®
5x6i
This addendum accompanies your EFX Assembly Guide. The upright supports tend to rub against the ramp if they are not properly aligned and
wrench tightened in the correct order. Refer to the table below and replace the appropriate step with the following:
When all fasteners are snug against the unit, wrench tighten them in
the order shown in the illustrations.
Step to replace
576i 8
556i 9
546i 7
Assembly Guide Addendum
49990-102, en
06 June 2008
556i
1st
4th
2nd
3rd
Wrench tighten the
fasteners on both
upright supports.
576i
Note: The same steps apply to the EFX546i
even though it is not shown above.
1st
4th
2nd
3rd
Wrench tighten the
fasteners on both
upright supports.