Precor P80 manual To tighten the fasteners properly, Center column support attachment

Assembling the EFX 27

3.Check alignments and thread the remaining four center column support screws, four ⁵₁₆-inch washers, and four split washers. Tighten with a ³₁₆-inch hex key so the assemblies come together, but leave room for adjustments.

Figure 9: Center column support attachment

To tighten the fasteners properly:

CAUTION: Upright support fasteners must be properly aligned and wrench-tightened in the order described below. If improperly assembled, the upright supports can rub against the ramp. Before you begin, verify that the base and lift covers are properly aligned and that the gap between them is even. If not, move the upright supports until the covers are properly aligned.

1.Fully tighten the two sets of fasteners on the back of the center column support.

Figure 10: Tighten fasteners on back of the center column support