Precor P80 manual Link arm attachment

Assembling the EFX 31

4.Fully tighten the fasteners using a ⁹₁₆-inch box-end wrench.

Figure 17: Link arm attachment

5.Align the cut-out inside the link arm cap with the link arm mounting hole. Apply pressure to the cap until it snaps into place.

To attach the upright support covers and pivot arm caps:

1.Place one inner and one outer upright support cover around one of the upright supports, aligning them so that the arrows on their inside surfaces point toward the front of the unit.

2.Line up the protrusions on the outer cover with the screw holes on the inner cover.

3.Apply pressure to both covers so that the protrusions fit firmly into the screw holes.

4.Secure the upright support covers using two self-tapping screws.

Figure 18: Upright support cover attachment (right-hand cover shown)