Precor manual Install Leg Press Option Cable Connection, S3.15 Assembly and Maintenance Guide

S3.15 Assembly and Maintenance Guide

9.Install Leg Press Option Cable Connection

Note: If you plan to attach the Multi-Hip or Leg Press Options, make sure that cable ends are on opposite sides of the Main Base. Do not position the cable ends as shown in this illustration.

A.Start at the Base Frame and feed the threaded end of Cable 130195 under the 3½-inch pulley. Attach the pulley to its base frame bracket using

one 2-inch hex head bolt one flat washer Wrench tighten.

B.Attach the threaded end of the cable to the Single Floating Pulley. Continue turning the screw at least three to four full turns to secure it inside the floating pulley housing.

			B
			1	- 2" zinc bolt
			A 1	- washer
1	2	3	4	5	6

Step 9. Install Leg Press Option Cable Connection

page 22