Precor S3.15 manual Cable Tension, D E A, Cable Adjustments and Maintenance, continued

S3.15 Assembly and Maintenance Guide

1. Cable Tension

If you experience any of these cable problems, take the following steps to reduce tension on the cables:

A.Place the Weight Pin in the Top Weight.

B.Place the Leg Press Support Arm in the upright (non-extended) position.

C.Position the Multi-Hip Pivot Arm so the cable remains centered between the two pulleys on the Multi-Hip Upright.

D.Check that the Press Arm rests lightly on the Bumper Pad and is positioned so it causes minimal tension in the cable. If necessary, rotate the Bumper Pad.

E.Adjust the threaded ends on the Single Floating Pulleys so the amount showing is the same on both pulleys. Retighten the jam nuts.

Note: You may need to loosen the jam nuts before making adjustments.

F.Adjust the Weight Stack threaded end. Retighten the jam nuts.

CAUTION: For safety reasons, always make sure to turn the screw three to four full turns so that the threads are engaged inside the Selector Stem or Floating Pulleys before tightening the jam nuts.

D

E

A

Align cable.

C Center it between the two pulleys.

Leg Support Arm in

B upright position.

F

1

2

3

4

5

6

Cable Adjustments and Maintenance, continued

page 27