! Caution !
Do not climb on the unit or try to move | Keep out of reach of children. Do not |
it once installed. | allow them to play on or near the unit. |
|
|
Do not place foreign objects or fingers | Important: Ensure that the plug remains |
into the air inlet/outlet. The fan runs at | clean, free from moisture, foreign objects |
high speed and can cause serious | and dirt. Ensure that the plug is properly |
injury. Do not operate the unit without | inserted or hard wired by a qualified |
the safety grill in place. | electrician. |
|
|
If the unit operates abnormally, stop |
|
the unit by firstly switching it off and | Do not clean the appliance with water. |
then unplug the unit. For example, if | Water will go into the unit and will destroy |
there is a strange smell or abnormal | the insulation. |
noise coming from the unit. |
|
|
|
Turn the unit off at the wall before | Do not pull on the cable to unplug the |
unplugging the unit. Do not disconnect | unit, damage to the plug and cable could |
the power while the unit is running. | occur |
|
|
| Ensure that the power to the heat pump is |
Do not touch the plug with wet hands, | disconnected before removing leaves, |
as electric shock can occur. | particles or other foreign objects from the |
| air inlet vanes. |
|
|
Verify the network specifications, with the unit data recorded on the heat pump prior to installation.
Any additional disinfectant systems, such as chemical or electrolysis are not recommended for use with this hot water heat pump. The pump MUST be installed prior to these systems.
For optimal operation of the heat pump, the following maximum values apply: A. Use of free chlorine : max : 2.6mg/l
B. Total bromine : max : 5.6mg/l
C. pH : between 6.5 and 8.0
Premier Heat Pumps – Water Heater and Chiller Manual | Page 5 |