2.Make any lateral shift adjustment and lock it by tightening the two (2) M6 x 30mm Phillips screws found on the bottom of the mounting brackets. Use the foot leveler to adjust your plasma.
CAUTION: Do not over tighten the M6 x 30mm screws to the rods (Figure 18).
NOTE: To remove the display from the wall simply back off the M6 x 30mm screws using a Phillips screwdriver and lift the unit of the wall carefully.
Lateral Shift
Wall Plate
Figure 18
NOTE: Although not depicted in the illustrations shown above, the width of this wall mount will encompass four wall studs (three studs if 24” apart).
Installation Manual | Page - 15 - |
