Pride Mobility 1107 Seat Position, Seatback Angle Adjustment, Manual Recline Seatback Adjustment

Models: 1107

1 51
Download 51 pages 2.1 Kb
Page 25
Image 25

V . C O M F O R T A D J U S T M E N T S

Seat Position

You can move the seat forward or rearward by changing the extrusion mounting position.

To change the position:

1.Unplugthecontrollerfromthepowerbase.

2.Remove the seat from the power base.

3.Removebothextrusionsfromthebottomoftheseat.Seefigure17.

4.Repositiontheextrusionsonadifferentsetofmountingholes. You must move both extrusions the same number of holes either forward or backward. See figure 17.

5.Fasten the extrusions back onto the bottom of the seat.

6.Reinstalltheseat.

7.Plug in the controller to the power base.

Seatback Angle Adjustment

If your power chair is equipped with an adjustable seatback, you can adjust it to four (4) different angles: 90°, 102°, 105°, or 107°.

To adjust the seatback angle:

1.Remove the seatback angle adjusting screw from each seat hinge. See figure 18.

2.Set the seatback at the desired angle.

3.Reinstall the seatback angle adjusting screw to each

Manual Recline Seatback Adjustment

If your power chair is equipped with a reclining seat, you can adjust the seatback angle with the seatback release lever. The lever is located on the right side of the seat base. See figure 5.

To adjust the recline angle:

1.Pull up on the seatback release lever.

2.Lean forward or backward to the desired position.

3.Release the lever.

Armrest Width Adjustment

You can change each armrest’s width independently of the other.

NOTE: Changing the armrest width may increase the overall width of your power chair.

Figure 17. Seat Position (Extrusion Location)

ARMREST ANGLE ADJUSTING SCREW

JAM

NUTS

SEATBACK

ANGLE

ADJUSTING

SCREW

ARMREST KNOB

Figure 18. Seatback Angle Adjustment

Jazzy 1107

www.pridemobility.com

25

Page 25
Image 25
Pride Mobility 1107 Seat Position, Seatback Angle Adjustment, Manual Recline Seatback Adjustment, Armrest Width Adjustment