V I I I . C A R E A N D M A I N T E N A N C E
CARE AND MAINTENANCE
Your Pride Power Chair is a sophisticated device. Like any motorized vehicle, it requires routine maintenance checks. You can perform some of these checks, but others require assistance from your authorized Pride Provider. Preventive mainte- nance is very important. If you follow the maintenance checks in this section as scheduled, you can help ensure that your power chair gives you years of
WARNING! Prevent injury. Do not service the power chair when the seat is occupied.
Your power chair, like most electrical equipment, is susceptible to damage from the elements. Avoid damp areas of any kind.
WARNING! Direct exposure to water or dampness could cause the power chair to malfunction electronically and mechanically. Water can cause electrical components to corrode and the chair’s frame to rust.
Should your power chair come in contact with water:
1.Dry your power chair as thoroughly as possible with a towel.
2.Allow your power chair to sit in a warm, dry place for 12 hours to allow unseen water to evaporate.
3.Check the joystick operation and the brakes before using your power chair again.
4.If any inconsistencies are found, take your power chair to your authorized Pride Provider.
Temperature
!Someofthepartsofyourpowerchairaresusceptibletoextremechangesintemperature.Alwayskeepyourpowerchairbetween the temperatures of 18° F and 122° F.
!In extremely cold temperatures the batteries may freeze. The specific temperature at which they freeze depends on a number of factors, such as battery charge, usage, and composition of the batteries (e.g.,AGM or
!Temperaturesabove122°Fmaycauseyourpowerchairtooperateatareducedspeed.Thisreducedspeedisasafetyfeaturebuilt into the controller that helps prevent damage to the motor and other electrical components. See VII. “Operation.”
General Guidelines
!Avoid knocking or bumping the controller, especially the joystick.
!Avoid prolonged exposure of your power chair to extreme conditions, such as heat, cold, or moisture.
!Keep the controller clean.
!Check all connectors to ensure that they are all tight and secured properly.
!Make sure the drive tires are inflated to 35 psi (2.4 bar) if equipped with pneumatic tires.
WARNING! Overinflating tires can cause them to explode and can result in personal injury.
WARNING! Do not use a high pressure hose to inflate your tires.
!Use a rubber conditioner on the tire sidewalls to help preserve them.
WARNING! Never use a rubber conditioner on the tread area of the tires; doing so may make the tires slippery and cause your power chair to skid.
!The body shroud has been sprayed with a clear sealant coating. You can apply a light coat of car wax to help it retain its
Jazzy 1107 | www.pridemobility.com | 41 |
