I I I . Y O U R P O W E R C H A I R

JAZZY 1107 SPECIFICATIONS

Suspension:

Active Trac

Drive Wheels:

10 in., pneumatic, (10 in., solid are optional)

 

 

Caster Wheels:

6 in., solid, rear-mounted

 

 

Anti-tip Wheels:

5 in., solid, front-mounted

 

 

Maximum Speed:¹

Up to 4.5 mph

 

 

Brakes:

“Intelligent Braking” electronic regenerative, disc park brake

 

 

GroundClearance:²

2.5 in.

 

 

TurningRadius:²

21.875 in. (with foot platform)

 

 

Overall Size:²

Length: 40.25 in. (with foot platform)

 

Width: 23.375 in.

 

 

Seating Options:

Medium-Back Seat (standard)

 

Limited Recline High-Back Seat (optional)

 

Full Recline High-Back Seat (optional)

 

Specialty Seat (optional)

 

 

Drivetrain:

Two motor, mid-wheel drive

 

 

Range:¹

Up to 25miles

 

 

Batteries:³

Two 12-volt, U-1 batteries, 32AH

 

 

Battery Charger:

5-amp,off-board

 

 

Electronics:

60-ampPrideFLIGHTController

 

50-amp PG Drives VSI Controller

 

 

Weight Capacity:

300 lbs.

 

 

Component Weights:

Base: 98 lbs. (right section 40.5 lbs.; left section 40.5 lbs.; center section 17 lbs.)

 

Medium-Back Seat: 37 lbs. (average weight with armrests and universal mounting system extrusions)

 

Batteries: 29 lbs. each (battery boxes 4.5 lbs. each)

¹Varies with user weight, terrain type, battery amp hour rating (AH), battery charge, battery condition, and tire condition. ²Due to manufacturing tolerances and continued product improvement, this specification can be subject to variance of (+ or – ) 3%.

³AGM or Gel-Cell type recommended.

NOTE: All specifications subject to change without notice.

Electrical Components

The electrical components consist of the controller assembly, the batteries, and the motors. The batteries, motors, and controller power module are located on the power base assembly. See figures 6 and 7. The controller is located on the seat assembly. Connectivity between the controller and the motors, the batteries, and the battery charger is provided by one or more wiring harnesses.

Controller Harness Connector: The controller harness connector is where the controller plugs into the power base. Each controller uses a different type of harness. If the controller has a power module in the power base, the connector is a small communications-type connector. If the controller is integrated, then the harness has a large 9-pin connector. Regardless of which type of controller is used, the harness must be secured to the seat assembly and not allowed to drag on the floor.

Jazzy 1107

www.pridemobility.com

17

Page 17
Image 17
Pride Mobility owner manual Electrical Components, Jazzy 1107 Specifications