V . A S S E M B L Y
Normally, your Jazzy is shipped fully assembled for your convenience. However, some seatbacks are removed for shipping purposes. The following is a set of instructions to help you quickly and easily prepare your Jazzy 1105 for immediate use. You will need a Phillips head screwdriver and a
PARTS LIST | QUANTITY |
Phillips Head seatback mounting screws | 4 |
Seatback | 1 |
1 |
SEATBACK ASSEMBLY
The seatback mounts to the back hinges with four (4) Phillips head screws.
To mount the seatback to the hinge:
1.Line up the hinges with the holes in the seatback.
2.Insert the seatback mounting screws through the hinge and into the seatback. See figure 5.
3.Tighten the four screws.
SEAT INSTALLATION
The standard seat installation method incorporates the seat frame
SEAT MOUNTING SCREW LOCATIONS
Figure 5. Seatback Assembly
WARNING! Do not pick up the seat frame by the armrests. They are free to pivot, and you may lose control of the seat if they do so, resulting in personal injury or damage to the chair.
To install the seat:
1.Set seat on the rear seat towers.
2.Push seat back and down until latches engage on the front seat towers.
3.Plug controller cable into the connector on the utility tray.
4.Plug power switch cable (if equipped) into the connector on the utility
tray.
5. Secure the controller cable to the armrest receiver with a wire tie.
CAUTION! Do not place the controller cable so that it can be pinched in the seat frame or the power base frame.
JOYSTICK INSTALLATION
Your Jazzy may have been shipped without the joystick installed in the armrest.
To install the joystick:
1.Use a
2.Slide the joystick mounting bracket into or out of the armrest to the desired
position.
3. Retighten the setscrew by it turning clockwise.
20 | www.pridemobility.com |
