V I . C O M F O R T A D J U S T M E N T S

ANTI-TIP WHEEL ADJUSTMENT

The anti-tip wheels are designed to give the Jazzy increased stability on rough surfaces. The anti-tip wheels are preset at the factory to a ground clearance height of 3/4-in. This setting is only for smooth surfaces or indoor use. If you plan on using your Jazzy on rough surfaces, it may be necessary to adjust the anti-tip wheels to better suit your needs.

The anti-tip wheels may need adjustment if either of the following occurs:

νWhen coming to a stop, the Jazzy tips forward excessively

νThe anti-tip wheels constantly rub the ground

Each drive tire must have 30–35 lbs. of pressure in order to adjust the anti-tip wheels properly.

To adjust the anti-tip wheels:

1.Remove the seat.

2.Use a 5/32-in. hex wrench to loosen and remove the hex screws that fasten the body shroud to the frame.

3.Remove the both body shrouds.

4.Adjust the 13-mm nut so that the anti-tip wheel is 1/2 to 1 inch off the ground. See figure 13.

5.Turn the nut clockwise to lower the anti-tip wheel and counterclockwise to raise the anti-tip wheels.

WARNING! Consult your authorized Pride provider before attempting to change the anti-tip wheel height! Changing the anti-tip wheel height affects handling under deceleration!

WARNING! The higher you raise the anti-tip wheels, the more you increase your power chair’s tendency to tilt forward when coming to a stop. You can compensate for this by having your authorized Pride provider make a small adjustment to the pre-programmed deceleration setting in the controller or by moving the seat assembly further to the rear of your power chair.

ANTI-TIP

ADJUSTMENT

NUT

Figure 13. Anti-tip Wheel Adjustment

24

www.pridemobility.com

Jazzy 1105/RevH/Feb03

Page 24
Image 24
Pride Mobility Jazzy 1105 owner manual ANTI-TIP Wheel Adjustment, To adjust the anti-tip wheels