V I I . D I S A S S E M B L Y
SEAT REMOVAL
You may wish to remove the seat when transporting your Jet 1. See figure 22.
To remove the seat:
1.Turn off the power.
2.Make sure your Jet 1 is not in freewheel mode.
3.Unplug the main wire harness behind the seat.
4.Push the lever located underneath the seat toward the front of the seat. If the joystick controller is on the right, swivel the seat clockwise and then pull the seat upward. If the joystick controller is on the left, swivel the seat counterclockwise and then pull the seat upward.
Figure 22. Removing the Seat
BODY SHROUD REMOVAL
The body shroud is a
To remove the body shroud:
1.Turn off the power.
2.Make sure your Jet 1 is not in freewheel mode. See IV. “The Jet 1.”
3.Unplug the controller wiring harness.
4.Remove the seat.
5.Lift the body shroud straight up. The body shroud is attached to the metal frame by reusable fasteners. The body shroud should lift up easily.
WARNING! Power chair batteries are heavy. See specifications table. If you are unable to lift that much weight, be sure to get help. Lifting beyond your capacity can result in personal injury.
BATTERY REMOVAL
To remove the batteries:
1.Turn off the power.
2.Disconnect the controller harness.
3.Remove the seat and lift off the body shroud.
4.Remove the battery post caps (both red and black).
5.Unscrew the wing nuts on (+) red battery terminals, one at a time.
6.Remove the (+) red battery cables from the battery posts; be sure to secure them away from the batteries.
7.Loosen the wing nuts on
8.Remove the
9.You can now remove the batteries from your Jet 1.
26 | www.pridemobility.com | US Jet 1 ATS/Rev B/Jul03 |
