Pride Mobility Revo owner manual A S I C Troubleshooting, Diagnostic Flash Codes

X . B A S I C T R O U B L E S H O O T I N G

Any electromechanical device occasionally requires some troubleshooting. However, most of the problems that may arise can usually be solved with a bit of thought and common sense. Many of these problems occur because the batteries are not fully charged or because the batteries are worn down and can no longer hold a charge.

DIAGNOSTIC FLASH CODES

The diagnostic flash codes for your scooter are designed to help you perform basic troubleshooting quickly and easily. Adiagnostic flash code will flash from the status LED in the event one of the conditions listed below develops.

NOTE: Your scooter will not run unless the flash code condition is resolved and the scooter has been turned off then turned back on.

FLASH CODE		CONDITION		SOLUTION
!	!	Battery voltage is too low to operate the	Charge fully until charger and any meters
	(2)	scooter.	indicate completion.
!	! !	Battery voltage is too high to operate the	Contact your authorized Pride Provider for
	(3)	scooter.	assistance.
! ! ! ! !		Solenoid brake trip. The manual freewheel	Remove the key, then push the manual freewheel
	(5)	lever may be in the freewheel position.	lever to the drive position, restart your scooter.
! ! ! ! ! !		Throttle trip. The throttle control lever	Release	the throttle control lever completely,
		may have been depressed while inserting
	(6)		then reinsert the key.
		the key.
! ! ! ! ! ! !		Throttle trip. Throttle potentiometer fault	Contact your authorized Pride Provider for
	(7)	or speed potentiometer fault.	assistance.
! ! ! ! ! ! ! !		The scooter’s motor is disconnected.	Contact	your authorized	Pride	Provider	for
	(8)		assistance.
		Possible controller trip. You may be	Shut down your scooter		for a	minimum	of
! ! ! ! ! ! ! ! !		attempting to install the battery pack while
			several minutes to allow the controller to cool.
	(9)	the key is inserted or the motor controller
			Or, try reinserting the key into the key switch.
		may be in overheat protective mode.

What if all the systems on my scooter seem to be “dead”?

!Make certain that the key is in the “on” position.

!Check that the batteries are fully charged.

!Push in the main circuit breaker reset button. See V. “Your Scooter.”

!Make certain that both batteries are seated properly.

!Make sure that the front-to-rear harness is firmly connected. See IX. “Disassembly and Assembly.”

!Be sure the power down timer feature hasn’t been activated. See VII. “Operation.”

What if my scooter does not move when I press the throttle control lever?

!When the manual freewheel lever is pushed forward, the brakes are disengaged and all power to the motor/ transaxle assembly is cut.

!Push back on the manual freewheel lever, turn the scooter off, and then turn the scooter on to return to normal scooter operation.

Revo www.pridemobility.com 35