V I I I . C O M F O R T A D J U S T M E N T S

ARMREST ADJUSTMENT

There is an armrest adjustment dial on the underside of each armrest. To adjust the armrest angle upward or downward while seated in your scooter:

νTurn the armrest adjustment dial to the left to lower the armrest angle or to the right to raise the armrest angle.

NOTE: The armrests also pivot upward to make getting on and off of your scooter easier.

POSITIONING BELT (Optional)

Your scooter seat may be equipped with an auto-type positioning belt that can be adjusted for operator comfort. See figure 17. The positioning belt is designed to help support the operator so that he or she does not slide down or forward in the seat. The positioning belt is not designed for use as a restraining device.

To install the positioning belt (if required):

1.Remove the seat from your scooter.

2.Place the seat upside down so that you can see the bottom of the seat base. See figure 17A.

3.Use a wrench to remove the two back bolts on the outermost part of the rear seat.

4.Insert the bolt through the appropriate ends of the positioning belt and then reinstall the bolts and belt back into the seat bottom.

5.Tighten the bolts.

To adjust the positioning belt for operator comfort:

1.Insert the metal tab on the right side of the belt into the plastic housing on the opposite strap until you hear a “click.”

2.Pull the strap on the right side of the belt until it is secure, but not so tight as to cause discomfort.

REMOVE BOLT

METAL TAB

REMOVE BOLT

PLASTIC

HOUSING

Figure 17. Positioning Belt

Figure 17A. Positioning Belt Installation

34

www.pridemobility.com

Victory XL-4/RevC/June03

Page 34
Image 34
Pride Mobility SC2700 owner manual Armrest Adjustment, Positioning Belt Optional