I X . D I S A S S E M B LY A N D A S S E M B LY

CAUTION! Failing to unplug both battery harnesses and the front-to-rear harness prior to further disassembly could result in permanent damage to your scooter.

9.Pull the frame lock lever all the way back. See figure 22.

10.While holding the lever back, lift up on the frame handle and push back on the seat post. The frame halves will separate. See figure 23.

FRAME HANDLE

FRAME LOCK LEVER

LOCKING PIN

CURVED BRACKET

MOUNTING PEG

Figure 22. Frame Lock

Figure 23. Separating Frame Halves

ASSEMBLY

1.Position the scooter halves as shown in figure 23.

2.Lift up on the frame handle and push back on the seat post.

3.Align the curved bracket of the front section with the mounting peg of the rear section and lower the front section onto the peg of the rear section.

4.Pivot the front and rear sections towards each other. The locking pin will lock into place.

5.Place the batteries into the battery wells, and fasten the battery straps.

6.Plug both battery harnesses into the battery harness connectors.

7.Plug the large, white, 9-pin front-to-rear connector into its mating plug coming from the rear.

8.(If equipped) Reconnect the handbrake cable by sliding the cable into its slot on the brake mount. With your thumb, push forward and hold the brake release lever, then slide the cable release hook onto the peg and gently let go of the brake release lever.

9.Plug the lighting harnesses back into their connectors before fully reinstalling the rear shroud.

10.Reinstall the seat.

Victory XL-4 /RevC/June03

www.pridemobility.com

37

Page 37
Image 37
Pride Mobility SC2700 owner manual Assembly