Pride Mobility Traveller Plus HD Why do my new batteries seem weak?, What about public transport?

Models: Traveller Plus HD

1 43
Download 43 pages 23.08 Kb
Page 25
Image 25
Why do my new batteries seem weak?

I V . B A T T E R I E S A N D C H A R G I N G

10.Position the lid back onto the battery pack.

11.Carefully turn the pack upside down.

12.Reinstall all screws and tighten.

NOTE: If you encounter a damaged or cracked battery, immediately enclose it in a plastic bag and contact your local disposal agency or authorized Pride Provider for instructions on disposal and bat- tery recycling which is our recommended course of action.

Why do my new batteries seem weak?

Deep-cycle batteries employ a different chemical technology than that used in car batteries, nickel-cadmium batteries (nicads), and other common battery types. Deep-cycle batteries are specifically designed to provide power, drain down their charge, and then accept a relatively quick recharge (8 to 14 hours).

We work closely with our battery manufacturer to provide batteries that best suit your Travel Scooter’s specific electrical demands. Fresh batteries are shipped fully charged to our customers. During shipping, the batteries may encounter temperature extremes that can influence their initial performance. Heat diminishes the charge on the battery; cold slows the available power and extends the time needed to recharge the battery. It may take a few days for the temperature of your Travel Scooter’s batteries to stabilize and adjust to their new room or ambient temperature.

More importantly, it takes a few charging cycles (partial draining followed by full recharging) to establish the critical chemical balance that is essential to a deep-cycle battery’s peak performance and long life.

Follow these steps to properly break in your Travel Scooter’s new batteries for maximum efficiency and service life.

1.Fully recharge any new battery prior to its initial use. This charging cycle brings the battery up to about 88% of its peak performance level.

2.Operate your new Travel Scooter in familiar and safe areas. Drive slowly at first and do not travel too far from your home or familiar surroundings until you have become accustomed to your Travel Scooter’s controls and have properly broken in your Travel Scooter’s batteries.

3.Fully recharge the batteries. They should be at over 90% of their peak performance level.

4.Operate your Travel Scooter again.

5.Fully recharge the batteries again.

6.After four or five charging cycles, the batteries are able to receive a charge of 100% of their peak performance level and are able to last for an extended period of time.

What about public transport?

If you intend to use public transport with your Travel Scooter, you must contact the transportation provider in advance to determine their specific requirements.

Elite Traveller Plus/Plus HD

www.pridemobility.com

25

Page 25
Image 25
Pride Mobility Traveller Plus HD manual Why do my new batteries seem weak?, What about public transport?