I X . C A R E A N D M A I N T E N A N C E
Your Travel Scooter requires a minimal amount of care and maintenance. If you do not feel confident in your ability to perform the maintenance listed below, you may schedule inspection and maintenance at your authorized Pride Provider. The following areas require periodic inspection and/or care and maintenance.
TIRE PRESSURE
!If equipped with pneumatic tires, always maintain the psi/bar/kPa air pressure rating indicated on each tire.
WARNING! It is important that the psi/bar/kPa air pressure rating indicated on each tire be maintained in pneumatic tires at all times. Do not underinflate or overinflate your tires. Low pressure may result in loss of control, and overinflated tires may burst. Failure to maintain the psi/bar/kPa air pressure rating indicated on pneumatic tires at all times may result in tire and/ or wheel failure.
!Regularly inspect your Travel Scooter’s tires for signs of wear.
EXTERIOR SURFACES
Bumpers, tires, and trim can benefit from an occasional application of a rubber or vinyl conditioner.
WARNING! Do not use a rubber or vinyl conditioner on the Travel Scooter’s vinyl seat or tire tread. They will become dangerously slippery.
CLEANING AND DISINFECTION
!Use a damp cloth and mild,
!If necessary, clean your product with an approved disinfectant. Make sure the disinfectant is safe for use on your product before application.
WARNING! Follow all safety instructions for the proper use of the disinfectant and/or cleaning agent before applying it to your product. Failure to comply may result in skin irritation or premature deterioration of upholstery and/or Travel Scooter finishes.
WIRING HARNESSES
!Regularly check all wiring connections.
!Regularly check all wiring insulation, including the charger power cord, for wear or damage.
!Have your authorized Pride Provider repair or replace any damaged connector, connection, or insulation that you find before using your Travel Scooter again.
PROHIBITED! Even though the Travel Scooter has passed the necessary testing requirements for ingress of liquids, you should keep electrical connections away from sources of dampness, including direct exposure to water or bodily fluids and incontinence. Check electrical components frequently for signs of corrosion and replace as necessary.
BATTERY TERMINAL CONNECTIONS
Make certain that the terminal connections remain tight and are not corroded.
34 | www.pridemobility.com | Elite Traveller Plus/Plus HD |
