Primera Technology AP360, 74293R, AP362 quick start Unpacking and Setup

Section 1: Unpacking and Setup

Thank you for purchasing the AP360 or AP362 Label Applicator (hereafter referred to as "Label Applicator"). Bottles, cans etc. will collectively be referred to as "containers." This manual applies to two label applicator models. The AP362 has a Control Panel that allows you to count labels and apply two labels to the same container. The AP360 does not have a Control Panel or two-label capability.

The Label Applicator includes a Power Cord, 12 volt Power Adapter and the parts shown in Figure 1-1.The Roll Bar, Roll Guides and Roll Drag Arm are located in the supply box along with the Power Cord. You will need to assemble them as shown in Figure 1-1.Attach the Power Cord and switch on the power as shown in Figure 1-2. Feed the Foot Switch and Foot Switch cord out through the front of the Label Applicator. Remove the tape securing the Container Rollers.

Figure 1-1.

	Roll Guides
Container Pressure Arm	Roll Bar
Liner Idler Roller
Liner Drive Roller
Container Guides
Container Idler
Roller
Container Drive	Control Panel
Roller	(AP362 only)
Label Sensor Flag
Label Sensor Bracket
Peel Edge
Figure 1-2.
	Roll Guides
	Roll Bar
Foot Switch
Power Switch
Power Input 12V
	Feed Area
Power Adapter	(under grey bar)
	Power Cord
	Roll Drag Arm

AP360/362 Label Applicator 3