![](/images/new-backgrounds/1298832/29883211x1.webp)
6.Now position the stock to correspond with the general area where the labels will be dispensed.
7.Pull the loose end of the label stock forward under the Top Roller. Pull approximately 6 inches of label stock out beyond the Peel Edge. (Figure
Figure
Tip! See Section 5 for a Label Path diagram.
8.Take the loose label stock and feed it between the Liner Idler Roller and the Liner Drive Roller. (Figure
Liner Idler Roller positions.)
Figure
Note: This procedure assumes that the first 6 inches of labels will not be dispensed using the Label Dispenser. Of course, you may still peel these labels by hand.