INSTALLATION | OPERATING YOUR HEATER |
CHECKING GAS
CONNECTIONS
WARNING: Test all gas piping and connections for leaks after installing or servicing. Correct all leaks at once.
WARNING: Never use an open flame to check for a leak. Apply a mixture of liquid soap and water to all joints. Bubbles forming show a leak. Correct all leaks at once.
Pressure Testing Gas Supply
Piping System
Test Pressures In Excess Of
1/2 PSIG (3.5 K Pa)
1.Disconnect appliance with its
appliance main gas valve (control valve) and equipment shutoff valve from gas supply piping system. Pressures in excess of 1/2 psig will damage heater regulator.
2.Cap off open end of gas pipe where equipment shutoff valve was connected.
3.Pressurize supply piping
s y s t e m b y | e i t h e r u s i n g | |
compressed | air | or opening |
propane/LP | supply tank valve. |
4. Check all joints of gas supply |
piping system. Apply mixture of |
liquid soap and water to gas |
Pressure Testing Heater Gas Connections
1.Open equipment shutoff valve (see Figure 15).
2.Open propane/LP supply tank valve.
3.Make sure control knob of heater is in the OFF position.
4.Check all joints from equipment shutoff valve to control valve (see Figure 16 ). Apply mixture of liquid soap and water to gas joints. Bubbles forming show a leak.
5.Correct all leaks at once.
6.Light heater (see Operating Heater, pages 10 and 11 for thermostat models or page 12 for
7.Turn off heater (see To Turn Off Gas To Appliance, page 11 for thermostat models or page 12 for
8.Replace lower front panel.
THERMOSTAT MODELS
FOR YOUR SAFETY
READ BEFORE LIGHTING
WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal injury or loss of life.
A. When lighting the pilot, follow , these instructions exactly.
B. BEFORE LIGHTING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor .
WHAT TO DO IF YOU SMELL GAS
Do not try to light any appliance. Do not touch any electric switch; do not use any phone in your building.
Immediately call your gas supplier from a neighbor’s
phone. Follow the gas supplier’s instructions.
If you cannot reach your gas supplier, call the fire department.
| joints. Bubbles forming | show |
| a leak. |
|
5. | Correct all leaks at once. |
|
6. | Reconnect heater and equipment | |
| shutoff valve to gas supply. Check | |
| reconnected fittings for | leaks. |
Test Pressures Equal To or Less Than 1/2 PSIG (3.5 K Pa)
1.Close equipment shutoff valve (see Figure 15).
2.Pressurize supply piping system by either using compressed air or opening propane/LP supply
tank valve.
3.Check all joints from gas meter to equipment shutoff valve (see Figure 16).Apply mixture of liquid soap and water to gas joints. Bubbles forming show a leak.
4.Correct all leaks at once.
C. Use only your hand to push in or turn the gas control knob. Never use tools. If the knob will not push in or turn by hand, don’t try to repair it, call a qualified service technician or gas supplier. Force or attempted repair may result in a fire or explosion.
D.Do not use this appliance if any part has been under water . Immediately call a qualified service technician to inspect the appliance and to replace any part of the control system and any gas control which has been under water.
1 0