PRODUCT FEATURES
SAFETY DEVICE
Astandard requirement for all
PIEZO IGNITION SYSTEM
This heater is equipped with a piezo ignitor. This system requires no matches, batteries, or other sources to light heater.
THERMOSTATIC HEAT CONTROL ON THERMOSTAT MODELS
These heaters have a control valve with a thermostat sensing bulb. This results in the greatest heater comfort and may result in lower gas bills.
LOCAL CODES
Install and use heater with care. Follow all local codes. In the absence of local codes, use the latest edition of National Fuel Gas code ANSZ223.1, also known as NFPA 54*.
*Available from :
American National Standards Institute, Inc. 1430 Broadway
New York, NY 10018 National Fire Protection Association, Inc.
Batterymarch Park
Quincy, MA 02269
UNPACKING
1.Remove heater from carton.
2.Remove all protective packaging applied to heater for shipment.
3.Check heater for any shipping damage. If heater is damaged, promptly inform dealer where you bought heater.
WATER VAPOR: A BY- PRODUC T O F U NV E N T E D R O O M H EAT ER S
Water vapor is a
(1)ounce (30ml) of water for every 1,000 BTU’s (3KW’s) of gas input per hour.
Unvented room heaters are recommended as supple- mental heat (a room) rather than a primary heat source (an entire house). In most supplemental heat applications, the water vapor does not create a problem. In most applications, the water vapor en- hances the low humidity atmosphere experienced during cold weather.
The following steps will help insure that water vapor does not become a problem.
1.Be sure the heater is sized properly for the application, including ample combustion air and circulation air.
2.If high humidity is experienced, a dehumidifier may be used to help lower the water vapor con- tent of the air.
3.Do not use an unvented room heater as the pri- mary heat source.
3
