Profile PCD970R installation instructions Trouble Shooting the System

TROUBLE SHOOTING THE SYSTEM

The following chart will help in solving most problems that may occur. Should any problem persist after you have made these checks, please consult your nearest Profile retailer. Before going through this check list, refer back to the wiring and operating procedures.

	ERROR CODES
E 1~ E 10	The unit cannot be operated because of trouble. Press the "RESET"
	button 25 . If the indicator still appears after pressing the "RESET"
	button 25 , your unit needs repair. Please refer to the warranty section
	of this manual for details on getting the unit serviced.
	.
SYMPTOM	CAUSE	SOLUTION
	New installation.	Press the RESET 25 button.
No Power	The vehicle's ignition switch	Turn the ignition switch to the accessory
	is not on.	position. If there is still no power, check the
		fuses at the vehicle's fuse block or the
		radio's fuse leads.
	The fuse is blown.	Replace the fuse with another fuse of the
		same recommended value
Disc cannot	There is a disc already in	Remove the disc in the player, then put in
be loaded or	the player.	the new one.
ejected.	You are trying to put the	Insert the compact disc with the label facing
	compact disc in upside down.	up.
	The compact disc is	Clean the compact disc with a compact disc
	extremely dirty or	cleaning solution or replace the defective
	defective.	compact disc.
	The temperature in the car	Cool the inside of the vehicle, then try again.
	is too hot.
	Condensation build-up on the	Leave the disc player off and turn the
	inside of the unit.	vehicle's air conditioner on to remove the
		condensation build-up inside the unit.
No sound.	The volume control is all the	Adjust the volume control.
	way down.
	The speakers are bad.	Test the speakers to determine if they need
		replacing.
The function	The built-in microprocessor	Remove the disc, then re-insert it. Press the
buttons do	is operating incorrectly.	reset button 25 .
not work.

17