ProForm 630 DS user manual Assembly, Uprights 82 down as shown

ASSEMBLY

Assembly requires two people.	Set the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials until assembly is completed.		Assembly requires the included allen wrench
and your own phillips screwdriver	.

Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.

1.With the help of a second person, carefully raise the treadmill to the upright position.

While a second person tips the treadmill to one side and

holds it, insert one of the Extension Legs (103) into the treadmill as shown. Make sure that the Extension Leg is turned so the Warning Decal (20) is on the top.

Next, tip the treadmill to the other side	and insert the
other Extension Leg (not shown) in the same way. L	ower
the side of the treadmill so that both Extension Legs
(103) are resting flat on the floor.
See HOW TO LOWER THE TREADMILL FOR USE on
page 14.

2. With the help of a second person, carefully tip the

Uprights (82) down as shown.	Make sure that the
Extension Legs (103) remain in the Uprights.

Attach each Extension Leg (103) with two long Screws (101) and a Thin Base Pad (127) as shown.

With the help of a second person, carefully tip the

Uprights (82) back to the vertical position.

Note: One replacement Thin Base Pad (127) and

Spacer (not shown) are included. If a Thin Base Pad

(127)becomes worn and needs to be replaced, use the replacement Base Pad. If a Thick Base Pad (97) needs to be replaced, use the replacement Base Pad with the Spacer.

1
20
	103
2	97
		127
		101
		103
82	127	97
	101
	103
	97

5