3.Locate the plastic tie in the post on the left Upright (82). Hold a Handrail Extension (85) in the position shown.
Insert the plastic tie into the Handrail Extension as you insert the Handrail Extension into the post. Attach the
Handrail Extension with three Screws (76). | Be careful to |
avoid damaging the pulse wire. The pulse wire is used |
|
with the optional chest pulse sensor (see page 14). |
|
Slide a Handrail Foam Grip (110) onto the Handrail
Extension (85). If it is difficult to slide on the Foam Grip, place a small amount of warm water and dish soap in the
Foam Grip. Press a Plastic Fastener (47) into the Handrail Foam Grip.
Attach the other Handrail Extension and Handrail Foam
Grip to the right Upright (not shown). Note: There is not a pulse wire in the right Upright.
4.Make sure that the Lock Knob Sleeve (111) is fully in- serted into the left Upright (82).
Remove the Lock Knob (102) from the Lock Pin (115).
Make sure that the Lock Pin Collar (113) and the Spring
(112)are on the Lock Pin. Insert the Lock Pin into the left Upright (82) and tighten the Lock Knob onto it.
5.Refer to figure 6a. Look at the left Rear Foot (59) at the back of the treadmill. If the left Rear Foot touches the floor, go to step 7. If there is a space between the left
Rear Foot and the floor, follow the instructions below.
Hold the treadmill firmly with both hands, and raise the treadmill to the storage position as described on page 19.
Refer to figure 6b. Using a ph | illips screwdriver, remove the |
Rear Foot Screw (60), the R | ear Foot (59) Rear Foot |
Spacer (120) from the right side. Reattach the right Rear Foot with the Screw. Hold the treadmill firmly with both hands, and lower the treadmill as described on page 19.
Check the left Rear Foot again (not shown). If the left Rear Foot is still off the floor, raise the treadmill and re- move the left Rear Foot. Snap the Rear Foot Spacer
(120)onto the left Rear Foot and reattach the Rear Foot and Spacer to the treadmill. Carefully lower the treadmill.
6.Make sure that all parts are tightened before you use
the treadmill. Keep the included allen wrench in a secure place. The allen wrench is used to adjust the walking belt (see
6page 17). To protect the floor or carpet from damage, place a mat under the treadmill.
3
Post
76
Plastic Tie
110 |
|
|
| 85 | 76 |
|
| 82 |
47 |
|
|
4 |
|
|
82 |
|
|
102 |
| 112 |
| 113 | |
|
| |
|
| 115 |
|
| 111 |
5a |
|
|
59 |
|
|
5b |
|
|
60 |
|
|
59 | 120 |
|
|
|
