ProForm 630 DS user manual Trouble-Shooting, Problem The power turns off during use, Solution

TROUBLE-SHOOTING

Most treadmill problems can be solved by following the steps below. Find the symptom that applies, and follow the steps listed. If further assistance is needed, please call our Customer Service Department toll-

free at 1-888-936-4266, Monday through Friday, 6 a.m. until 6:30 p.m Eastern Time (excluding holidays).

PROBLEM: The power does not turn on

SOLUTION: a.Make sure that the power cord is plugged into a surge protector, and that the surge protector is plugged into a properly grounded outlet. (See HOW TO PLUG IN THE POWER CORD on page

7.) Use only a CUL-listed surge protector, rated at 15 amps, with a 14-gauge cord of five feet or less in length.

b. After the power cord has been plugged in, make sure that the key is fully inserted into the con- sole. See step 1 on page 9.

c. Check the circuit breaker located on the treadmill near the power cord. If the switch protrudes as shown, the circuit breaker has tripped. To reset the circuit breaker, wait for five minutes and then press the switch back in.

d. Check the on/off switch located on the treadmill near the power cord. The switch must be in the on position.

PROBLEM: The power turns off during use

c
Tripped	Reset
d	On
	Position

SOLUTION: a. Check the circuit breaker located on the treadmill frame near the power cord (see 1. c. above). If the circuit breaker has tripped, wait for five minutes and then press the switch back in.

b. Make sure that the power cord is plugged in.

c. Remove the key from the console. Reinsert the key fully into the console. See step 1 on page 9.

d. Make sure that the on/off switch is in the on position.

e. If the treadmill still will not run, please call our Customer Service Department.

PROBLEM: The speed display on the console does not function properly

SOLUTION:	a. Remove the key from the console and		unplug the
	power cord.	Remove the screws from the hood and
	carefully remove the hood. Locate the Reed Switch			1/8”
	(21) and the Magnet (43) on the left side of the Pulley				42
				76
	(42). Turn the Pulley until the Magnet is aligned with
					43
	the Reed Switch.	Make sure that the gap between		21
	the Magnet and the Reed Switch is about 1/8”.			If
	necessary, loosen the Reed Switch Screw (76) and			Top
	move the Reed Switch slightly. Retighten the Screw.
				View
	Re-attach the hood, and run the treadmill for a few
	minutes to check for a correct speed reading.

PROBLEM: The pulse display on the console does not function properly

SOLUTION: a. Wash your hands prior to using the pulse sensor. Clean the sensor with a damp cloth and a little dish soap.

b. Make sure that there is not a bright light or direct sunlight shining directly on the pulse sensor.

15