![](/images/new-backgrounds/1271323/27132315x1.webp)
•As you walk or run on the treadmill, position yourself near the center of the walking belt. For the console to display heart rate readings, the user must be within arm’s length of the console.
•The chest pulse sensor is designed to work with people who have normal heart rhythms. Heart rate reading problems may be caused by medical conditions such as premature ventricular contractions (pvcs), tachycardia bursts, and arrhythmia.
•The operation of the chest pulse sensor can be affected by magnetic interference caused by high power lines or other sources. If it is suspected that magnetic interference may be causing a problem, try relocating the treadmill.
•The CR 2032 battery may need to be replaced.
Locate the battery cover |
| |
on the back of the sen- |
| |
sor unit. Insert a coin |
| |
into the slot in the cover, |
| |
turn the cover counter- |
| |
clockwise, and remove |
| |
it. Remove the old bat- |
| |
tery and insert a new CR |
| |
2032 battery, making |
| |
sure that the battery is | CR 2032 | |
turned so the writing is | ||
Battery | ||
on top. Make sure that | ||
| ||
the rubber gasket is in | Rubber | |
place in the sensor unit. | Gasket | |
Replace the battery |
| |
cover and turn it clock- |
| |
wise to close it. |
|
HOW TO USE THE HAND PULSE SENSOR
The convenient hand pulse sensor allows you to measure your heart rate without wearing the chest pulse sensor. You can measure your heart rate before you begin exercising, during your workout, and again when you finish.
To use the hand pulse sensor, the console must be turned on (see HOW TO TURN ON THE POWER on page 11.) In addition, the walking belt must be moving or the TIME/PACE display must be flashing (see step 5 on page 12).
Next, stand on the foot rails and place your hands
on the metal con- tacts. Your palms
must be resting on the upper contacts, and your fingers must be touching the lower contacts— avoid moving your hands while
measuring your heart rate. After a moment, three dashes (– –
HAND PULSE SENSOR TROUBLE-SHOOTING
•Make sure to stand on the foot rails and avoid moving your hands while measuring your heart rate. Excessive movement may interfere with heart rate readings. If the hand pulse sensor is not used correctly, three dashes (– –
•Do not hold the metal contacts too tightly; doing so may interfere with heart rate readings.
•For the most accurate heart rate reading, wait for about 15 seconds.
•For optimal performance of the hand pulse sensor, keep the metal contacts clean. The contacts can be cleaned with a soft
8