4.Hold a Bolt Spacer (79) inside the lower end of the Right Upright (78). Insert an M10 x 96mm Bolt (5) with an M10 Star Washer (8) into the Right Upright and the Bolt Spacer. Repeat this step with a second Bolt Spacer (79), M10 x 96mm Bolt (5), and M10 Star Washer (8). Hold the Right Upright (78) against the Right Upright Spacer (80). Be careful not to pinch the Upright Wire (77). Partially tighten the M10 x 96mm Bolts (5); do not fully tighten the
Bolts yet.
Press a Base Endcap (82) into the Base (85).
5.With the help of a second person, carefully tip the treadmill onto its right side. Partially fold the Frame (48) so the treadmill is more stable; do not fully fold the Frame yet.
Remove and discard the two indicated bolts (A) and the shipping bracket (B).
Attach a Base Pad (81) to the Base (85) in the location shown with a Base Pad Spacer (104) and an M4.2 x 25mm Tek Screw (2). Then, at- tach a Base Pad (81) in the location shown with only an M4.2 x 25mm Tek Screw (2).
Remove the M10 Nut (33), the M10 x 50mm Bolt (4), and the shipping bracket (C) from the Base (85). Attach a Wheel (86) with the Bolt and the Nut that you just removed. Do not over- tighten the Nut; the Wheel must turn freely. Discard the shipping bracket.
4 |
|
| 5 |
|
|
|
|
| 78 |
|
|
| |
|
|
| 8 77 |
| ||
|
|
|
| 79 | ||
|
|
|
| 8079 | 82 | |
|
|
|
| 85 |
|
|
5 | A | B |
|
|
|
|
|
|
|
|
| ||
|
|
|
|
|
| |
2 | 81 |
|
| 48 | 4 |
|
104 |
|
|
| |||
| 85 |
| 86 |
|
| |
| 2 | 81 | C |
| ||
|
|
| ||||
|
|
|
| 33 |
| |
8
