WIRING THE RESTORATION 5.1
The RESTORATION 5.1 is designed to operate with a 240 volt AC power source; it must be wired by a qualified electrician directly into a 240 volt AC GFCI in your home. The steps below are intended to be used as a reference for the qualified electrician who wires your spa and installs the 240 volt AC GFCI in your home. WARNING: Only a qualified electrician should perform this procedure.
1.Remove the two indicated Control Unit Screws (19) and the two Small Star Washers (8) from the cover on the Control Unit (14). Fold the cover down.
Route the 240 volt AC power cord through the indi- cated opening on the right side of the Control Unit (14).
2.Attach the 240 volt AC power cord to the indicated wires inside the Control Unit (14) as shown in the diagram to the right.
1 |
|
|
|
|
| 14 | 8 |
| Feed the |
|
| power cord in | ||
|
|
|
| through this |
|
|
|
| opening |
|
|
|
| 19 |
2 |
|
| Wire Nut | |
|
|
| ||
|
|
|
| White |
|
|
|
| Wire Nut |
|
|
|
| Green |
| N | White |
| Blue |
| Blue |
| ||
| L2 |
|
| |
|
| Wire |
| |
| L1 | Black |
| |
|
| Nut | Black | |
|
|
| ||
|
|
|
| |
14 | 240 volt AC Power Cord | |||
3.Determine if the 240 volt AC power supply in the home is a 30 amp supply or a 40 amp supply. If the home power supply is a 30 amp supply, go to step 4.
If the home power supply is a 40 amp supply, go to step 5.
4.For a 30 amp, 240 volt AC power supply, set the jumper J1 to pins 2 and 3 on the power board and leave the other jumpers at the factory settings, as shown at the right. At 30 amps, there is not enough amperage to operate the heater and the pump at high speed simultaneously. Go to step 6.
4
Jumper settings for a 240 volt AC,
30 amp power supply
10
