ProForm 831.21005 user manual SET-UP and Assembly

SET-UP AND ASSEMBLY

Before beginning assembly, carefully read the following information and instructions:

¥Place all parts in a cleared area and remove the packing materials from the spa shell; do not dis- pose of the packing materials until assembly is completed and the spa is in operation.

¥Assembly requires two people.

¥During assembly, make sure that all parts are ori- ented as shown in the drawings.

¥Read each assembly step before you begin.

¥Tighten all parts as you assemble them, unless instructed to do otherwise.

ASSEMBLY REQUIRES THE FOLLOWING TOOLS (not included):

¥One (1) phillips screwdriver

¥You may also need some soap or wax.

1.Before beginning assembly, be sure that you have read and understand the information on the previous two pages.

Remove the four access cover screws from the access cover. Remove the access cover from the Spa Unit (15) by sliding the access cover down and pulling the bottom of access cover away from the Spa Unit. Be careful not to damage the spa shell.

2.Locate and check the position of the cut-off valves. Occasionally the valves will be closed at the factory during manufacturing. The cut-off valves must be open for proper spa operation. To open the valves, hold one of the handles and turn the handle until you can pull it out to the open position. Open the other valve in the same manner. WARNING: THE

MOTOR WILL BE DAMAGED IF IT IS OPERATED WITH THE CUT-OFF VALVES CLOSED.

Close the valve knob on the drain hose. Thread the cap onto the drain hose. Thread the drain plug into the Pump Motor (13). Tighten the pump fittings.

1
	Spa
	Shell		15
	Access	Access Cover
	Cover
			Screws
2			Cut-off Valve
Cut-off
Valve
			13
			Drain Hose
Cap	Valve	Drain	Pump
	Knob	Plug	Fittings

8