5.For a 40 amp 240 volt AC power supply, set the jumper J1 to pins 1 and 2 on the power board and leave the other jumpers at the factory settings, as shown at the right. This will allow the heater and the pump to operate at high speed simultaneously.
5
Jumper settings for a 240 volt AC,
6.Secure the power cord by tightening the screws in the wire clamp on the Control Unit (14).
6
40 amp power supply
14
Screws
Power Cord
Wire
Clamp
7.Close the cover on the Control Unit and secure the cover with the two Control Unit Screws and the two Small Star Washers removed in step 1.
8.Install the 240 volt GFCI at the source voltage to conform with national electrical codes.
9.Attach the power cord to the 240 volt AC power source. Be sure that the 240 GFCI is in place.
10.Test the GFCI for proper operation.
11.Attach the access cover to the Spa Unit (15) by inserting the top of the cover under the edge of the spa shell. Be sure the 240 volt power cord is routed through the notch in the cover. Slide the cover into place and secure the cover with the four access cover screws.
11 | Spa |
|
| Shell | 15 |
240 volt
Power Cord
Access | Access Cover | |
Cover | ||
Screws | ||
|
11
