ProForm 831.21005 user manual Spa Shell Diagram

SPA SHELL DIAGRAM

G

A

C

A

B

E F

D

B

B

A

D

AA

SPA OPERATION

Refer to the diagram above. The function of each component is explained below:

The eight uni-directional thera-jets (A) are located on both sides of the spa. Five jets focus the water massage on your upper or lower back. The remaining three jets provide a foot hydro-massage for three of the seating positions.

The six multi-directional thera-jets (B) can be adjusted for a custom hydro-massage. Each thera-jet can also be shut off by being pressed in and turned back on by pulling the jet back out. Two of the jets are located on the reclining seat and focus the water massage on your lower back. Two more jets are locat- ed on each of the bench seats, and focus the water massage on your lower or middle back.

The filter (C) can be removed for replacement and cleaning (see CHECKING AND CLEANING THE FIL- TER on page 16).

The suction vents (D) located near the floor of the spa brings the water into the pump in order to operate the system. The suction covers should always be in place over the suction vents. Never operate the spa without the suction covers in place.

This spa is ozone ready. An optional ozone generator can be installed to utilize the ozone jet (E). Ozone provides a way to help sanitize your spa with minimal chemical treatment.

The temperature probe (F) reads the current water temperature, which is displayed on the console.

The RESTORATION 5.1 also has a light (G) for your safety and convenience during evening use.

The RESTORATION 5.1 features automatic freeze protection. If the water temperature falls below 40¡F, the pump will begin circulating and heating the water to prevent the water from freezing.

13