9.Identify the Left Upper Body Arm (8), which is marked with an “L” sticker. Orient the Left Upper Body Arm and the left Upper Body Leg (6) as shown; make sure that the hexagonal holes in the Left Upper Body Arm are in the indicated location.
Slide the Left Upper Body Arm (8) onto the left Upper Body Leg (6). Attach the Left Upper Body Arm with two M6 x 38mm Button Bolts (76) and two M6 Nylon Locknuts (77); make sure that the Nylon Locknuts are inside the hexagonal holes.
Repeat this step for the Right Upper Body Arm and the right Upper Body Leg (not shown).
9
8
| 77 |
76 | Hexagonal |
| Holes |
| 6 |
10.Apply a generous amount of the included grease to the Pivot Axle (16). Then, apply a small amount of grease to two Wave Washers (88).
Insert the Pivot Axle (16) into the Upright (2). Place a Wave Washer (88) on each end of the Pivot Axle.
Slide the left Upper Body Leg (6) onto the Pivot Axle (16). Attach the left Upper Body Leg with an M6 x 16mm Button Screw (80) and a Large Axle Cover (20). Attach the right Upper Body
Leg (6) in the same way.
10 |
| |
80 | 2 | |
| ||
20 | 16 | |
| ||
6 | 88 | |
20 | ||
| ||
| 80 | |
| 88 | |
| Grease | |
| 6 |
10
