2.Remove the 3/8" Nut (8), the 3/8" x 2" Bolt (4), and the shipping bracket (C) from the Base (80). Attach a Base Wheel (81) with the Bolt and the Nut that you just removed. Do not overtighten the Nut; the Wheel must turn freely. Discard the shipping bracket.
Cut the tie off the Upright Wire (78).
3.Identify the Right Upright (72) and the Right Upright Spacer (74), which are marked with stickers. Insert the Upright Wire (78) through the Right Upright Spacer as shown.
See the inset drawing. Tie the wire tie in the Right Upright (72) securely around the end of the Upright Wire (78). With the help of a second person, hold the Right Upright near the Base (80). Then, pull the other end of the wire tie until the Upright Wire is routed completely through the Right Upright.
2 |
|
|
|
| Tie |
|
| 78 |
|
| 80 |
|
| 4 |
|
| 81 |
|
| C |
|
| 8 |
3 |
| Tie |
|
| |
|
| 72 |
| 78 | 78 |
|
| |
|
| 74 |
|
| 80 |
|
| 72 |
Wire
78 
Tie
4. Hold a Bolt Spacer (3) inside the lower end of | 4 |
| |
the Right Upright (72). Insert a 3/8" x 4" Bolt (6) |
| ||
6 |
| ||
with a 3/8" Star Washer (9) into the Right |
| ||
|
| ||
Upright and the Bolt Spacer. Repeat this step | 72 |
| |
with a second Bolt Spacer (3), 3/8" x 4" Bolt (6), |
| ||
|
| ||
and Star Washer (9). | 9 |
| |
Hold the Right Upright Spacer (74) and the | 78 | 3 | |
|
| ||
Right Upright (72) against the Base (80). Be | 80 |
| |
careful not to pinch the Upright Wire (78). |
|
| |
Finger tighten the 3/8" x 4" Bolt (6); do not fully | 3 | 75 | |
tighten the Bolts yet. | |||
74 |
| ||
|
| ||
Press a Base Endcap (75) into the Base (80). |
|
| |
| 7 |
|
