ProForm 831.28544.2 user manual

12. Identify the Left Pedal (13) and the Left Pedal Leg	12			13
(14), which are marked with stickers.
Attach the Left Pedal (13) to the Left Pedal Leg (14)
with an M4 x 45mm Screw (108), three M4 x 14mm
Screws (104), and four Star Washers (112).
Attach the Right Pedal (not shown) to the Right Pedal
Leg (not shown) in the same way.	112		112	14
	104		108
			112	112
13. Apply a thin film of grease to one of the Pedal Leg Axles	13			104
(32) and to the faces of the two Pedal Leg Bushings
(33) in the Left Pedal Leg (14).
Next, slide an M8 Washer (88) and a Pedal Leg Cover
(31) onto an M8 x 23mm Shoulder Screw (115), and	11			12
turn the Shoulder Screw a few turns into the Pedal Leg			3188
Axle (32).		31		115
While another person holds the front end of the Left	88			33
Pedal Leg (14) inside of the bracket on the Left Upper
Body Arm (11), insert the Pedal Leg Axle (32) into both	115		Grease
parts. Next, slide an M8 Washer (88) and a Pedal Leg
Cover (31) onto another M8 x 23mm Shoulder Screw	Grease		32
(115), and turn the Shoulder Screw a few turns into the
Pedal Leg Axle. Tighten both Shoulder Screws.
Repeat this step to attach the Right Pedal Leg (not
shown) to the Right Upper Body Arm (12).				14
14. Lift the latch on the underside of the Left Pedal Leg	14
(14), and set the Left Pedal Leg on the left Crank
Bushing Sleeve (43). Release the lever, and make sure
that the Left Pedal Leg is securely connected to the
Crank Bushing Sleeve.		14
Connect the Right Pedal Leg (not shown) in the same
way.			Latch
See step 5. Tighten the M8 x 69mm Button Bolt (80)				43
and the two M8 x 23mm Button Screws (84).

15.Make sure that all parts of the elliptical exerciser are properly tightened. Note: Some hardware may be left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the elliptical exerciser.

9