9
HOW TO OPERATE THE CONSOLE
Note: The console requires two ÒAAÓ batteries. See
assembly step 4 on page 7 for battery installation
instructions.
1. To turn on the power, press the on/reset button or
simply begin pedaling. When the power is turned
on, the entire display will appear for two seconds.
The console will then be ready for operation.
2. Select one of the six modes:
Scan modeÑ
When the power
is turned on, the
scan mode will
automatically be
selected. One
mode arrow will
show that the
scan mode is
selected, and a
flashing mode arrow will show which mode is cur-
rently displayed. Note: If a different mode is select-
ed, you can select the scan mode again by repeat-
edly pressing the mode button.
Speed, time, dis-
tance, fat calo-
ries, or calories
modeÑTo select
one of these
modes for contin-
uous display,
press the mode
button repeated-
ly. The mode arrows will show which mode is
selected. Make sure that the scan mode is not
selected.
3. To reset the display, press the on/reset button.
4. To turn off the power, simply wait for about four
minutes. Note: The monitor has an Òauto-offÓ
feature. If the pedals are not moved and the
monitor buttons are not pressed for four min-
utes, the power will turn off automatically in
order to conserve the batteries.
HOW TO USE THE PULSE SENSOR
Note: Before you can use the pulse sensor, you
must peel the protective vinyl covering off the
metal contacts on the top and bottom of the pulse
sensor.
To use the pulse
sensor, place
your hands on
the metal con-
tacts. Your
palms must be
resting on the
upper contacts
and your fingers
must be touch-
ing the lower
contacts. Avoid
moving your hands.
After a moment, the heart-shaped indicator in the dis-
play will begin to flash, three dashes (Ð Ð Ð) will
appear and then your heart rate will be shown. For
the most accurate heart rate reading, continue to hold
the contacts for about 15 seconds.
Note: If your heart rate is not shown, press the
reset button to reset the pulse sensor.In addition,
make sure that your hands are positioned as
described above. Be careful not to move your hands
excessively or squeeze the metal contacts too tightly.
Mode Arrows
Mode Arrow
Metal
Contacts
WARNING:The pulse sensor
is not a medical device. Various factors,
including the user's movement, may affect
the accuracy of heart rate readings. The
pulse sensor is intended only as an exer-
cise aid in determining heart rate trends in
general.