HOW TO ADJUST THE BELT
The exercise cycle features a precision belt that must be kept properly adjusted. If the belt causes exces- sive noise or slips as you pedal, the belt should be checked. To do this, the left side shield must first be removed. Refer to the instructions on page 12 and remove the left
side shield. |
|
Next, use an |
|
adjustable | 16 |
wrench to turn |
|
the right pedal |
|
counterclock- |
|
wise and |
|
remove it. |
|
Remove the |
|
right side |
|
shield. |
|
Press down on the center of the Belt (16) between the front and rear sprockets. There should be from 1/4Ó to 3/4Ó of vertical movement in the center of the Belt.
If the Belt (16) is properly adjusted, reattach the side shields and pedals. If the Belt needs to be adjusted, loosen the M8 Washer Nut (37) on each side of the
Flywheel (32). |
|
To tighten the |
|
Belt, turn the |
|
two M6 Stop | 16 |
nuts (47) clock- |
|
wise; to loosen | 32 |
the belt, turn | |
the Nuts coun- |
|
terclockwise. |
|
Make sure that | 37 |
the Flywheel is | 47 |
| |
straight and |
|
tighten the M8 |
|
Washer Nuts (37). Reattach the side shields and | |
pedals. |
|
13
