CONSOLE DIAGRAM

Note: If there is a thin sheet of clear

 

plastic on the console, remove it.

Key

 

 

 

 

 

Clip

CAUTION: Before operating the console, read the following precautions.

Do not stand on the walking belt when turn- ing on the power.

Always wear the clip (see the drawing

above) while using the treadmill. When the key is removed from the console, the walk- ing belt will stop.

Adjust the speed in small increments.

The training zones marked above the speed control are general guidelines only. See

page 14 for more information.

To reduce the possibility of electric shock, keep the console dry. Avoid spilling liquids on the console and use only a sealable water bottle.

BATTERY INSTALLATION

The console requires two or three "AA" batteries (not included). Alkaline batteries are recommended. Open the battery cover as shown in the drawing at the upper right. Insert the batteries into the battery com- partment, making sure that the negative (–) ends of the batteries are touching the springs in the battery com- partment.

 

Battery

Tab

Batteries

Cover

 

Close the battery cover, push up on the battery cover tab, and then push the tab forward as shown in the inset drawing. Make sure that the tab locks into place.

STEP-BY-STEP CONSOLE OPERATION

Before operating the console, make sure that the power cord is properly plugged in (see page 7).

Stand on the foot rails of the treadmill. Find the clip at- tached to the key (see the drawing at the top of this page), and slide the clip onto the waistband of your

clothes. Next, insert the key into the console. Test the clip by carefully taking a few steps backward until

the key is pulled from the console. If the key is not pulled from the console, adjust the position of the clip as needed.

8

Page 8
Image 8
ProForm 831.291710 Console Diagram, Adjust the speed in small increments, for more information, Battery Installation